• ​Power Module (model CP3000AC54TEZ)
• ​Power Shelf (we have a J2014003L001)
• ​ATCA-F140 Switch

---

IMPORTANT NOTES

• The COB's insertion lever's sensor is broken and you must run clia commands to install/uninstall it.

To install: Insert COB as you normally would and then run the following command to tell the shelf the lever is correctly sent clia sendcmd 0x96 0x2e 0x08 0x0a 0x40 0x00 0x00 0x01 Where 0x96 is the IPMI address for the physical slot 2 and logical slot 11

---

Log

2016-09-12 Dan

config file updates for sane fan trays

/etc/rc.comtel

#CARRIER_OPTIONS="USE_DEFAULT_COOLING=TRUE" # enables default cooling strategy (non-zoned)
CARRIER_OPTIONS="USE_DEFAULT_COOLING=TRUE" # enables default cooling strategy (non-zoned)

/etc/shelfman.conf.comtel

#MIN_FAN_LEVEL = 40
MIN_FAN_LEVEL = 1

/etc/shelfman.conf

# COOLING_FAN_DECREASE_TIMEOUT = 0                                            
COOLING_FAN_DECREASE_TIMEOUT = 1        
# COOLING_FAN_INCREASE_TIMEOUT = 0                                            
COOLING_FAN_INCREASE_TIMEOUT = 1           

#COOLING_POLL_TIMEOUT =30                                                       
COOLING_POLL_TIMEOUT =5                                                       

2016-09-12

• Using a POT, the power shelf output voltage was set to 48V

• Controller pinout

J1 pin/color	Arduino pin	use
13/brown		SCL_0
15/red		SDA_0
18/white		Alert#_0
19/orange		\EN_B
21/blue		\EN_A
20/brown		ground
22/red		ground