wiki:Raspberry Pi Setup

To set up the Raspberry Pi for this system, do the following:

  • Burn the latest raspbian image onto an SD card (>16GB, preferably 32GB to be safe)
  • Boot up a Raspberry Pi B+ with the SD card in it and proper peripherals connected (monitor, mouse, keyboard, ethernet)
  • Check out the software repository
    • Make a directory "~/work/"
    • Within the Work directory, run the following command:
    • svn co gauss.bu.edu/svn/mri-stimulator/software
      
  • Make sure the directory smbus2 is included in your software directory.
  • Configure the Raspberry Pi settings to enable SSH and I2C
  • Find and note the IP of the Raspberry Pi.
  • If the IP is lost or the pi moves to a new IP address, it can be found elsehow, but within the EDF it should be easy enough to keep the pi on the same IP address.
Last modified 4 years ago Last modified on Mar 1, 2019, 2:19:01 PM