This page describes a new monkey timer apparatus being developed for Doug Rosene''s lab at the BUMC.

=== Documentation ===
* Version 2 (under construction in 2011)
 * [http://edf.bu.edu/~cjlawlor/MonkeyTimer2/monkeypictures Pictures of version 2]
 * [http://ohm.bu.edu/~vryoung/monkey_sensors/ Sensor and IR LED Boards]
 * [http://edf.bu.edu/~cjlawlor/MonkeyTimer2/Monkey2_Sensor_Wire_Harness.jpg Sensor Wire Harness]
 * [http://ohm.bu.edu/~pbohn/MONKEY-TIMER-2/Design_Files/ Version 2]
 * [http://ohm.bu.edu/~hazen/monkey/Rev2/MonkeyTimer_Mark2_c.pdf Preliminary Specification]
 * [http://ohm.bu.edu/~hazen/monkey/Rev2/SensorSketch2.pdf SensorSketch2.pdf]
 * [http://arduino.googlecode.com/files/arduino-0022.dmg arduino-0022.dmg]
 * [http://arduino.cc/en/Guide/MacOSX Connection Guide]

 * Serial Parameters (If you see weird gibberish on the link check that your terminal parameters are set correctly)
  * Port: /dev/tty.usbmodemXXXX (where XXXX is some numbers.  NOTE: the device needs to be plugged into the computer for this device to show up) 
  * Speed:               57600 baud
  * End of line format:  
   * inbound: CR or LF
   * outbound: CR + LF
  * Character Size:      8
  * Stop Bits:           1
  * Parity Bits:         0
  * Flow Control:        None


 * [http://edf.bu.edu/~cjlawlor/MonkeyTimer2/monkey_timer_2.2.zip Firmware version 2.2]
 * [http://edf.bu.edu/~cjlawlor/MonkeyTimer2/monkey_timer_2.1.zip Firmware version 2.1]
 * [http://edf.bu.edu/~cjlawlor/MonkeyTimer2/monkey_timer_2.0.zip Firmware version 2.0]

* [http://ohm.bu.edu/~hazen/monkey/ Version 1]