wiki:Full Version

Version 69 (modified by James, 7 years ago) (diff)

--

This page describes the revisions to the test-beam version of the electronics needed to create the full g-2 tracker electronics.

Board Database:

LogicBoardID TDCMotherBoardID TDCBoardID FeedthruBoardID FlexicableID ASDQBoardID

Outstanding issues after the test beam

In general, everything worked well at the test beam. Here's a (potentially incomplete) list of things that we want to test/get working before a full production run. The last two are firmware and we don't need to wait for them.

  • CDR locking - this works well about 75% of the time but fails and we get garbled data back from the TDCs. Re-running the intialisation (without a power-cycle) often fixes this. We think that this is all related to which CDR edge the automatic system locks on to.
  • Temperature sensors - some ECOs required already but it'd be good to make sure we can read these out properly before running the full run.
  • Remote loading of firmware - make sure we can do this with our current layouts. Part of this should be re-visiting the programming cable connection which is very very flaky right now.
  • Flexi-length modifications - longest flexi is about 5 mm too long - others seems OK.
  • Reset counters via C5 commands
  • Hit edge studies - why don't we see both hit edges for all hits? Can we do anything about this or do we just need to remove these hits. They seem to happen when they're close together. There looks to be useful physics information in the width so we would like to understand this.
  • Hit LSB timing histogram - does the new firmware have reasonable timing for the 0.625 ns bins?

Logic Board

Logic Board DB

  • LogicBoardDbECOs Logic board DB ECOs
  • LogicBoardDbID Logic board DB IDs and info
  • update 805 0.1 ohm resistors to correctly be 805 and not 805 wide
  • Add 1uF capacitors on the current monitor voltage divider
  • Update reset signal to correctly be not reset

TDC Motherboard

TDC Daughter-Board

  • TDCBoardID TDC board IDs and info
  • Parts Notes:
    • Install at P1, P2 plugs TD-103-G-A-1
  • firmware

Feedthru Board

Flexi cables

ASDQ Board

The ASDQ Board (v3) is mechanically more compact and intended to stack end-to-end on large chambers. The test pulse injection drivers and voltage regulators have been removed from the design.

ASDQ v3 had socket holes that were too small. v4 is identical with the exception that these holes are larger.

High Voltage Board

High Voltage Cables

  • Wire -- Daburn CRT24-2.5 03. Marginally too fat to fit in connectors but best we could find
  • Connectors: two options
    • Molex
      • 0050579003 (WM2801) 3 pin housing
      • 0050579005 (50-57-9005) 5 pin housing
      • 0016020087 (WM2512) crimp terminal 22-24 AWG
    • Harting
      • M20-1060300 (952-2228-ND) 3 pin housing
      • M20-1060500 (952-2230-ND) 5 pin housing
      • M20-1180042 (952-2158-ND) Crimp pins

Both work, though the Molex seem to fit the wire a bit better.

Mechanical Info for "Electronics Inside" Option

General updates

End to End Noise Scan Testing

Attachments (2)

Download all attachments as: .zip