Changes between Version 14 and Version 15 of FilamentSupply_RevA_Testing_1_31_20


Ignore:
Timestamp:
Feb 6, 2020, 1:49:59 PM (3 years ago)
Author:
Michael
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • FilamentSupply_RevA_Testing_1_31_20

    v14 v15  
    22
    33
    4 == HVPulser Rev A testing 1/16/20 ==
     4== Filament Supply Rev A testing 1/31/20 ==
    55
    66'''Setup:''' The attached photos show the setup used for testing the Filament Supply. For this test 120VAC was supplied to the board through a 6-pin Molex connector from a variac. For the first test the BNC used to supply input voltage was capped with a 100ohm resistor to ground. For the other test, the input voltage was supplied across this BNC connector. A 25ohm 10W resistor was used as a test load.[[BR]][[Image(http://gauss.bu.edu/svn/tof-system/Gallery/2020-01-31/Setup.jpg, 15%, link=[http://gauss.bu.edu/svn/tof-system/Gallery/2020-01-31/Setup.jpg])]][[Image(http://gauss.bu.edu/svn/tof-system/Gallery/2020-01-31/Load.jpg, 15%, link=[http://gauss.bu.edu/svn/tof-system/Gallery/2020-01-31/Load.jpg])]]