Breakout board for testing SM without CM.

This should be an ExpressPCB mini board with the following connectors (CM side)

The power contacts should be routed with large copper areas (40A capable if possible!) to a set of series power resistors (6 each DigiKey? TEH100M2R50FE-ND)

Signal contacts should be routed as follows:

JTAG: TMS, TCK, TDO, TDI with GND to a 6 pin SIP header (Digilent pinout):

1 - TMS
2 - TDI
3 - TDO
4 - TCK
5 - GND
6 - N/C

To a 0.1 inch dual row header:

1 - PWR_GOOD
2 - EN
3 - TX_IPMC
4 - RX_IPMC
5 - TX_ZYNQ
6 - RX_ZYNQ
7 - SENSE_SDA
8 - SENSE_SCL
9 - GPIO0
10 - GPIO1
11 - GPIO2
12 - PS_RST
13 - GND
14 - GND

Loop back Tx to Rx via 0.1 pairs (ideally on a header). Keep traces short as possible.

TX1_P - RX1_P etc. Ground all GND pins.

Clock pairs should have 100 ohm between N/P and route to 0.1" pairs