Warnings
- R147 is currently 0-Ohms and would then connect power enable from the carrier board to 12V! This should be removed or replaced with a large resistor for protection.
- R161 connects 12V to 3.7 Volts. Please remove
TODO
- Add pin 1 mark on U5
- The incorrect flash was chosen and shorts out 3.3V. This can be fixed by melting off the package and cutting traces.
- R161 connects 12V to 3.7 Volts. This should be changed or replaced with a large resistor
- U30 requires ECO to change buffer direction Link http://ohm.bu.edu/trac/edf/attachment/wiki/ADC-RevC-ECO/G2%20quad%20pulser%20U30%20ECO.pdf
- Y1 requires ECO to swap pin 4 and 6 Link http://ohm.bu.edu/trac/edf/attachment/wiki/ADC-RevC-ECO/g2%20quad%20Y1%20ECO.pdf
- R158 change 10K to 1K
Last modified 5 years ago
Last modified on Nov 8, 2017, 4:46:38 PM
Attachments (3)
-
G2 quad pulser U30 ECO.pdf (198.1 KB) - added by 5 years ago.
g2-quad rev C U38 ECO
-
g2 quad Y1 ECO.pdf (238.5 KB) - added by 5 years ago.
g2-quad rev C Y1 ECO
-
G2 quad pulser U22 ECO.pdf (1.2 MB) - added by 5 years ago.
ECOs to be done on U22 after ECOs from U30
Download all attachments as: .zip