Changes between Version 1 and Version 2 of 6V6PPAmp
- Timestamp:
- May 13, 2022, 10:14:55 AM (2 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
6V6PPAmp
v1 v2 1 1 === Push-Pull 6V6 amp (~ 10WPC) 2 3 This could possibly be a first kit or commercial amp. Hammond iron and tube rectification 4 is appealing, but relatively expensive. 2 5 3 6 * https://diyaudioprojects.com/Schematics/DIY-Push-Pull-PP-6V6-Tube-Amplifier/ 4 7 * Note on phase splitter: https://www.bonavolta.ch/hobby/en/audio/split.htm#Paraphase 5 8 * Some [http://diyaudioprojects.com/Forum/viewtopic.php?f=9&t=6305 useful notes] 9 10 Seems like it might need a pre-amp stage. Maybe the cascade tubes "universal preamp"? 11 12 Notes from "Jim_O" on diyaudioprojects forum: 13 14 The original schematic showed an option to use EL84 / 6BQ5 tubes instead of the 6V6. Just a different cathode resistor. If I had to do it over again I probably would have used the EL84's. Beefier tube and probably a little more output. About the only place I deviated from the original design was the power supply. I used an Antek toroid PT (ugly but effective) AS1T230 with two 230 vac secondaries. I connected them in series, forming a 460 vac CT winding and fed a 2-diode full-wave rectifier setup, feeding a CRC filter with two 250 uf electrolytics and a 50 ohm , 10-watt resistor in between. That gave me a little over 300 vdc B+. I used AC for the heaters. No audible hiss or hum. 15